Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
en:hardware:red [2017/09/26 09:47] TobiasVo created |
en:hardware:red [2018/08/17 21:20] (current) gerbold ↷ Links adapted because of a move operation |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== System RED ====== | ====== System RED ====== | ||
+ | |||
+ | Index of the [[http://en.blitzortung.org/Compendium/Documentations/Documentation_2014-05-11_Red_PCB_10.4_PCB_12.3_PCB_13.1_PCB_14.1.pdf|Documentation of System RED]] | ||
+ | |||
+ | [[en:about#introduction|1 Introduction]]\\ | ||
+ | [[en:about:participating|2 Participating]]\\ | ||
+ | [[en:detection|3 Lightning detection and locating]]\\ | ||
+ | [[en:detection:lightning-discharge|3.1 Lightning discharge]]\\ | ||
+ | [[en:detection:lightning-discharge#receiving_a_lightning_signal|3.2 Receiving a lightning signal]]\\ | ||
+ | [[en:detection:lightning-discharge#time-of-arrival_method|3.3 Time-of-Arrival method]]\\ | ||
+ | [[en:detection:lightning-discharge#the_blitzortungorg_network|3.4 The Blitzortung.org network]]\\ | ||
+ | [[en:detection:lightning-discharge#accuracy|3.4.1 Accuracy]]\\ | ||
+ | [[en:hardware|4 Lightning detection hardware]]\\ | ||
+ | [[en:hardware:antennas|4.1 Antennas]]\\ | ||
+ | [[en:hardware:antennas:h-field:loop|4.1.1 Loop antennas]]\\ | ||
+ | [[en:hardware:antennas:h-field:loop#frame_antennas|4.1.1.1 Frame antennas]]\\ | ||
+ | [[en:hardware:antennas:h-field:loop#coaxial_cable_antennas|4.1.1.2 Coaxial cable antennas]]\\ | ||
+ | [[en:hardware:antennas:h-field:loop#other_loop_antennas|4.1.1.3 Other loop antennas]]\\ | ||
+ | [[en:hardware:antennas:h-field:ferrite-rod|4.1.2 Ferrite rod antennas]]\\ | ||
+ | [[en:hardware:antennas:h-field:ferrite-rod#shielding_ferrite_rod_antennas|4.1.2.1 Shielding ferrite rod antennas]]\\ | ||
+ | [[en:hardware:antennas:h-field:ferrite-rod#self-made_ferrite_rod_antennas|4.1.2.2 Self-made ferrite rod antennas]]\\ | ||
+ | [[en:hardware:antennas:h-field:ferrite-rod#housing|4.1.2.3 Housing]]\\ | ||
+ | [[en:hardware:antennas:h-field:ferrite-rod#shielding_of_magnetic_antennas|4.1.3 Shielding of magnetic antennas]]\\ | ||
+ | [[en:hardware:antennas:e-field|4.1.4 Electrical antennas]]\\ | ||
+ | [[en:hardware:red:amplifier#amplifier|4.2 Amplifiers]]\\ | ||
+ | [[en:hardware:red:amplifier:amplifier12#amplifier_12|4.2.1 Amplifier 12]]\\ | ||
+ | [[en:hardware:red:amplifier:amplifier12#electronic_parts|4.2.1.1 Electronic parts]]\\ | ||
+ | [[en:hardware:red:amplifier:amplifier12#connecting_an_antenna|4.2.1.2 Connecting an Antenna]]\\ | ||
+ | [[en:hardware:red:amplifier:amplifier12#gain_control|4.2.1.3 Gain Control]]\\ | ||
+ | [[en:hardware:red:amplifier:amplifier12#connecting_the_controller|4.2.1.4 Connecting the controller]]\\ | ||
+ | [[en:hardware:red:amplifier:amplifier12#output_test_pins|4.2.1.5 Output test pins]]\\ | ||
+ | [[en:hardware:red:amplifier:amplifier12#first_hardware_check|4.2.1.6 First hardware check]]\\ | ||
+ | [[en:hardware:red:amplifier:amplifier12#amplifier_pcb_change_log|4.2.1.7 Amplifier PCB change log]]\\ | ||
+ | [[en:hardware:red:amplifier:amplifier13#amplifier_13|4.2.2 Amplifier 13]]\\ | ||
+ | [[en:hardware:red:amplifier:amplifier13#electronic_parts|4.2.2.1 Electronic parts]]\\ | ||
+ | [[en:hardware:red:amplifier:amplifier13#gain_control|4.2.2.2 Gain Control]]\\ | ||
+ | [[en:hardware:red:amplifier:amplifier13#connecting_the_controller|4.2.2.3 Connecting the controller]]\\ | ||
+ | [[en:hardware:red:amplifier:amplifier13#output_test_pins|4.2.2.4 Output test pins]]\\ | ||
+ | [[en:hardware:red:amplifier:amplifier13#first_hardware_check|4.2.2.5 First hardware check]]\\ | ||
+ | [[en:hardware:red:amplifier:amplifier14#pre-amplifier_14|4.2.3 Pre-Amplifier 14]]\\ | ||
+ | [[en:hardware:red:amplifier:amplifier14#electronic_parts|4.2.3.1 Electronic parts]]\\ | ||
+ | [[en:hardware:red:amplifier:amplifier14#connecting_amplifier_pcb_13|4.2.3.2 Connecting Amplifier PCB 13]]\\ | ||
+ | [[en:hardware:red:amplifier:amplifier14#connecting_an_antenna|4.2.3.3 Connecting an Antenna]]\\ | ||
+ | [[en:hardware:red:amplifier:amplifier14#first_hardware_check|4.2.3.4 First hardware check]]\\ | ||
+ | [[en:hardware:red:controller|4.3 Controller]]\\ | ||
+ | [[en:hardware:red:controller#controller_10x|4.3.1 Controller 10.x]]\\ | ||
+ | [[en:hardware:red:controller#electronic_parts|4.3.1.1 Electronic parts]]\\ | ||
+ | [[en:hardware:red:controller#stm32f4discovery_board|4.3.1.2 STM32F4DISCOVERY board]]\\ | ||
+ | [[en:hardware:red:controller#leds|4.3.1.3 LEDs]]\\ | ||
+ | [[en:hardware:red:controller#display|4.3.1.4 Display]]\\ | ||
+ | [[en:hardware:red:controller#buzzer|4.3.1.5 Buzzer]]\\ | ||
+ | [[en:hardware:red:controller#gps_module|4.3.1.6 GPS Module]]\\ | ||
+ | [[en:hardware:red:controller#amplifier_connectors|4.3.1.7 Amplifier connectors]]\\ | ||
+ | [[en:hardware:red:controller#ethernet|4.3.1.8 Ethernet]]\\ | ||
+ | [[en:hardware:red:controller#grounding|4.3.1.9 Grounding]]\\ | ||
+ | [[en:hardware:red:controller#serial_interface|4.3.1.10 Serial interface]]\\ | ||
+ | [[en:hardware:red:controller#first_hardware_check|4.3.1.11 First hardware check]]\\ | ||
+ | [[en:hardware:red:controller#controller_pcb_change_log|4.3.1.12 Controller PCB change log]]\\ | ||
+ | [[en:hardware:red:powersupply|4.4 Power supply]]\\ | ||
+ | [[en:hardware:red:powersupply#poe|4.4.1 PoE]]\\ | ||
+ | [[en:hardware:red:assembling|4.5 Assembling advice]]\\ | ||
+ | [[en:hardware:red:assembling#parts_with_a_low_mounting_height|4.5.1 Parts with a low mounting height]]\\ | ||
+ | [[en:hardware:red:assembling#parts_with_a_medium_mounting_height|4.5.2 Parts with a medium mounting height]]\\ | ||
+ | [[en:hardware:red:assembling#parts_with_a_high_mounting_height|4.5.3 Parts with a high mounting height]]\\ | ||
+ | [[en:hardware:red:operation|5 Operating instructions]]\\ | ||
+ | [[en:hardware:red:operation:fw_installation#firmware_installation|5.1 Firmware Installation]]\\ | ||
+ | [[en:hardware:red:operation:fw_installation#flash_by_using_on-board_programmer|5.1.1 Flash by using on-board programmer]]\\ | ||
+ | [[en:hardware:red:operation:fw_installation#dfu_method|5.1.2 DFU Method]]\\ | ||
+ | [[en:hardware:red:operation:fw_installation#flash_through_the_web-interface|5.1.3 Flash through the web-interface]]\\ | ||
+ | [[en:hardware:red:operation:user_interface|5.2 User interfaces]]\\ | ||
+ | [[en:hardware:red:operation:user_interface#web-interface|5.2.1 Web-Interface]]\\ | ||
+ | [[en:hardware:red:operation:user_interface#leds|5.2.2 LEDs]]\\ | ||
+ | [[en:hardware:red:operation:user_interface#buttons|5.2.3 Buttons]]\\ | ||
+ | [[en:hardware:red:operation:user_interface#lc_display|5.2.4 LC display]]\\ | ||
+ | [[en:hardware:red:operation:user_interface#buzzer|5.2.5 Buzzer]]\\ | ||
+ | [[en:hardware:red:operation:user_interface#debug_logging|5.2.6 Debug Logging]]\\ | ||
+ | [[en:hardware:red:operation:interference|5.3 Interference Mode]]\\ | ||
+ | [[en:hardware:gnss|5.4 GPS]]\\ | ||
+ | [[en:hardware:firmware:technical_background|5.5 General mode of operation]]\\ | ||
+ | [[en:hardware:firmware:technical_background#about_the_firmware|5.5.1 About the firmware]]\\ | ||
+ | [[en:hardware:firmware:technical_background#flash_and_settings|5.5.2 Flash and settings]]\\ | ||
+ | [[en:hardware:firmware:technical_background#start-up_sequence|5.5.3 Start-up Sequence]]\\ | ||
+ | [[en:hardware:firmware:technical_background#real-time-clock|5.5.4 Real-Time-Clock]]\\ | ||
+ | [[en:hardware:firmware:technical_background#watchdogs|5.5.5 Watchdogs]]\\ | ||
+ | [[en:hardware:firmware:technical_background#server_connections|5.5.6 Server connections]]\\ | ||
+ | [[en:hardware:firmware:technical_background#detecting_signals|5.5.7 Detecting signals]]\\ | ||
+ | [[en:hardware:firmware:special_features|5.6 Special features]]\\ | ||
+ | [[en:hardware:firmware:special_features#actions_and_alerts|5.6.1 Actions and Alerts]]\\ | ||
+ | [[en:hardware:firmware:special_features#as3935_franklin_lightning_sensor|5.6.2 AS3935 Franklin Lightning Sensor]]\\ | ||
+ | [[en:hardware:firmware:special_features#user_i_os|5.6.3 User I/Os]]\\ | ||
+ | [[en:hardware:firmware:special_features#analogue_user_input|5.6.4 Analogue user input]]\\ | ||
+ | [[en:hardware:red:differences|6 Differences to the old hardware]]\\ | ||
+ | [[en:support|7 Support and Help]]\\ | ||
+ | [[en:support:problems|7.1 Common Problems]]\\ | ||
+ | [[en:support:faq|7.2 Frequently asked questions]]\\ | ||
+ | [[en:appendix|8 Appendix]]\\ | ||
+ | [[en:appendix#acknowledgement|8.1 Acknowledgement]]\\ | ||
+ | [[en:appendix#translations|8.2 Translations]]\\ | ||
+ | [[en:appendix#changes|8.3 Changes]]\\ | ||
+ | [[en:glossary|Glossary]]\\ | ||
+ | [[en:references|References]] | ||